You are currently viewing Don’t Falter On Fall Protection

Don’t Falter On Fall Protection

Falls on a worksite are one of the most serious and also common injuries. In the construction industry, slips, trips, and falls are far and beyond the most common cause of fatal injuries. Working at heights is a necessity in construction and the hazards associated with this type of work will always be present. However, there are proactive controls you can put in place to minimize the risk associated with this hazard. Here are a few best practices to implement, if not already done so, in your workplace to protect your employees.

Controlled Access Zone

When working near an unprotected edge, workers should utilize proper fall protection. In the absence of proper fall protection, certain sections of the roof that have an unprotected edge should be restricted. An unprotected edge is a elevated platform without a physical barrier or guardrail at least 39 inches in height. If a section of the workplace with this characteristic is identified, a controlled access zone must be implemented.

A controlled access zone is delineated by a control-line or some other means of restricted access. This zone must be no less than 6 feet and no more than 25 feet from the edge. This protective physical delineation should run parallel with the unprotected edge. In so doing, you will prevent your employees from accidentally treading too close to an unprotected edge. Workers allowed in this area must be trained on the hazards associated with this workspace and measures to keep themselves and others free from injury. With these precautions in place, you can minimize the risk of your workers falling off an unprotected edge while on the job.

Use Proper Guardrails

Not all guardrails are the same. As eluded to in the section above, OSHA has specific requirements for the characteristics of a guardrail. The components of an approved guardrail include:

  • Height must be between 39 and 45 inches from the walking surface.
  • Midrails must be installed midway between the top bar and walking surface.
  • No opening can be wider than 19 inches.
  • The guardrail must be able to withstand 200 pounds of force applied to the guardrail in any direction.
  • Toeboards must be installed when there is a risk of objects falling below.

By utilizing a properly installed guardrail, you can prevent workers from falling through or pushing over what they may have assumed was a protective barrier.

Personal Fall Arrest System

While this topic alone could fill several articles, I will address the basics in this section. The above parts discuss different methods of fall prevention. Personal fall arrest is part of fall protection. The difference is, when a worker falls over the edge, a fall arrest system, not a guardrail, may be the only thing that can save them. However, there are many considerations to take into account before selecting the correct device for your workers.

There are many types of fall arrest devices that can be utilized. Harnesses, lanyards, beam wraps, and rope-grabs. The first aspect to consider is if the fall arrest device is short enough to prevent the worker from hitting the ground before the device has the ability to activate. Consider an employee working at a platform elevated 15ft, if the employee is 6’2″ tall, with a 6ft lanyard and 5ft shockwave stretch component. If that individual falls off the edge, they will hit the ground before their fall arrest system has the ability to fully activate. One of the best parts of a fall arrest harness is the fact that it disperses the weight from the fall evenly across parts of the body. In this scenario, however, the worker’s legs will take the brunt of the falling force which could likely lead to broken ankles and weeks of recovery.

Final Thoughts

Keeping your workers safe while working near serious hazards is a difficult job. Fall hazards are no exception to this. While it is impossible to prevent all risk while on the job, a savvy business leader will identify and control the hazards they can identify and proactively address. For help in this area and to keep you workers safe, please consider reaching out for support. We don’t bite and will work with your site leadership to augment your site’s existing safety plan.